1
General Discussion / Re: Help: Change Current WAN with new ISP Public IP
« on: September 29, 2022, 08:57:18 pm »
So I was finally successful on changing IP and Gateway for new ISP. After doing alot of digging with the "gateway address does not lie within one of the chosen interface's IPv4 subnets.", it appears you have to select "Far Gateway" first for it to work and then take it off later (some were saying its a bug. I am on 21.1.3_3) This allowed to save the WAN interface IP along with saving new Gateway information. This in return updated the WAN DHCPIPv4 section under Services with proper Subnet, Mask and Range.
I then had to go into the failover settings to then assign the new WAN to a Tier for the failover policy for our 2 connections as it will take it off since the old WAN interface no longer in use. (If anyone has this setup for Failover)
thanks for the help
I then had to go into the failover settings to then assign the new WAN to a Tier for the failover policy for our 2 connections as it will take it off since the old WAN interface no longer in use. (If anyone has this setup for Failover)
thanks for the help