Messages

I am completely lost right now how to get to mutli-want working with gateway groups. So here is my setup:

1) Multiple WANs - ATT and COMCAST
2) Mulitple Gateway Groups
3) Primary Gateway group is member down
4) ATT is Tier 1 and COMCAST is Tier 5
5) All traffic goes out the COMCAST port for some reason rather than the ATT port

To my understanding everything should be going out the ATT since it's tier 1.

1) ATT Gateway priority is 246
2) COMCAST Gatway priority is 254.

Please tell me if I'm mis-reading that the Tiers are supposed to be where Tier 1 is primary and the other tiers are less important as you move down or did I mix that up?

I'm not sure if this is the correct place, but I have four interfaces. 2 wan interfaces, 1 lan, 1 VLAN.

1 WAN and 1 LAN use the Dell 10Gb interfaces cards
1 WAN is a aquntic interface

Both of WAN and the LAN that is on the Dell 10Gb interface card show up in zenarmor, but the one that is the other interface does not. I know I probably should just replace the interface, but I hoping not to have to spend any more money on this box lol.

The aquntic interface I do have to compile the kernel drivers from source using the ports download in the documentation.

Is the reason why it doesn't show up in the Zenarmor because it isn't compatible?

So, I just found out the gateway that I have to use from my isp has a max sessions of 8125. Is it just me or is that really small? I fell like two people gaming and another watching Netflix could blow that out of the water in a second. Please tell me if I'm wrong.

I currently have a LAGG interface and I'm trying to see if the issue I'm experience is caused by flapping or something else.

The port overview shows the following:
LAGG Statistics   active ports:2
flapping:2

Does this mean I am having issues with my interface?