Messages

Hi All,

I developed this issue last week where the connection gets dropped randomly and requires multiple restarts before it will connect again.

It appears to be a DHCP issue obtaining IP from ISP but I have no clue how to fix it as all I have changed is the patch updates.

I have captured the log as below. Any help to resolve this is appreciated.


opnsense- /usr/local/etc/rc.newwanip: The WAN_DHCP monitor address is empty, skipping.

opnsense- /us/local/etc/rc.newwanip: The WAN_DHCP6 monitor address is empty, skipping.

opnsense- /usr/local/etc/rc.newwanip: ROUTING: skipping IPv6 default route

opnsense- /us/local/etc/rc.newwanip: ROUTING: IPv6 default gateway set to optl

opnsense- /us/local/etc/rc.newwanip: ROUTING: keeping current default gateway

opnsense- /usr/local/etc/rc.newwanip: ROUTING: setting IPv4 default route to

opnsense- /us/local/etc/rc.newwanip: ROUTING: IPv4 default gateway set to wan

opnsense- /usr/local/etc/rc.routing_configure: The WAN_DHCP monitor address is empty, skipping.

opnsense- /usr/local/etc/rc.routing_configure: The WAN_DHCP monitor address is empty, skipping.

opnsense- /usr/local/etc/rc.routing_configure: The 10G_DHCP monitor address is empty, skipping.

opnsense- /us/local/etc/rc.newwanip: ROUTING: entering configure using 'wan'

opnsense- /us/local/etc/rc.routing_configure: ROUTING: skipping IPv6 default route

opnsense- /usr/local/etc/rc.routing_configure: ROUTING: IPv6 default gateway set to opt1

I was able to log in to serial with PUTTY but shows no options. If I type "sudo ifconfig igb0 up" it doesn't change, i still can't access web gui.

Any assistance to enable LAN interface or reset to factory greatly appreciated.

Hi all, new to OPNSENSE.

I had a working fine setup with a DEC2750 when I accidentally turned off the LAN interface (the only one) trying to switch it to another physical port on the firewall. It logged me out as I was connected via that interface.

Now I only have WAN interface as assigned port and have no way of logging into OPNsense. I tried serial via the guide however, command can't find the directory to screen it. I'm not sure if it was even set up.

How can I log back in to assign a interface or even factory reset (doesn't seem to be a button on the firewall).

TIA