Messages

Hi all ,
is there a way to configure a vpn client not site-to-site ( remote access only ) ?

I don't find the client mode on the opnsense client config.

thank's.

OK , I reply by myself....

openvpn client use LOCAL router address to connect so U don't need to use a gateway group,
you only need to set the gateway to move on router config and it works.

Now I have a site-to-site vpn that have two wan on a side and two wan on the other side and if ANY wan
interface go down it move the traffic to remain on line.

really nice.

Bye all.

Hi All, I'm trying to configure a multi-wan openvpn client.

My multi-wan works , I have a gateway group and a rule on lan policy that redirect all connection to gateway group.

The problem is that when main gw go down my lan continue to work BUT opnsense itself ( the router ) don't change the gateway.

I can't set a rule as I have auto-created rules that say (self) should go trought default gateway.

So also openvpn client that have source ip of the router don't switch gateway and go down.

Is there a way to remove auto-generated or add a rule before ? 
Is that the right way to do that ? Or I can set some rule specific for openvpn client in some place ?

Thank's in advance,
marco.