"
I should also mention that "Block private networks" and "Block bogon networks" are turned off
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / New to Opnsense; 100% Packet loss
May 18, 2022, 12:54:04 AM
Hey all, we've just setup OPNsense today but are struggling massively with the firewall.
Overview:
We are running a VMWare network on subnet 192.168.25.0/24
Gateway is 192.168.25.2
Opnsense is on 192.168.25.131 configured to use the gateway above
Other machines are on 192.168.25.125 to 192.168.25.130
Issue being: Other machines cannot connect to squid or DNS if the source and destination is set to LAN nor can opsense connect to the gateway (no packets go through, even if ICMP is allowed)
Log:
But the rules explicitly allow LAN connections
Setting all rules to ANY works however opnsense itself does not have any connection to the gateway cannot ping the gateway nor any other ip address
What am I doing wrong?
Overview:
We are running a VMWare network on subnet 192.168.25.0/24
Gateway is 192.168.25.2
Opnsense is on 192.168.25.131 configured to use the gateway above
Other machines are on 192.168.25.125 to 192.168.25.130
Issue being: Other machines cannot connect to squid or DNS if the source and destination is set to LAN nor can opsense connect to the gateway (no packets go through, even if ICMP is allowed)
Log:
But the rules explicitly allow LAN connections
Setting all rules to ANY works however opnsense itself does not have any connection to the gateway cannot ping the gateway nor any other ip address
What am I doing wrong?
Pages1
