Messages

I would also like to know how to change the colours as well !

Thank you for the help.

I have 3 x opnsense fire walls running on Asus Z370-i motherboards with 1Gig Dell Intel PRO/1000 VT Quad Port Gigabit Ethernet Cards installed in the PCIE slots.

Everything runs without issues or errors.

My ISP in the next couple of months is upgrading to a 3Gig connection so i have been looking at upgrade options for the network card to 10GB.

The issue is the cards I have tested all produce Interface Errors between the Opnsense fire wall and the 10GB MikroTik switch using either ethernet or SFP+ connectors

These are the cards I have tested.

Intel X550-T2 Dual Port 10Gb ethernet
Intel X540-T2 Dual Port 10Gb ethernet
Intel X520-DA2 Dual port 10GB SFP+

Do i have to make changes to system setting to opnesense or load software for the cards ?

Where do you add the instructions

kldload if_cxgbe

to enable the Chelsio T520-CR network card as i have the same issue.

Thank you for the solution, setting service to custom fixed my dynamic dns with no ip. :)