Messages

Hello,
I have setup the FreeRadius plugin and have everything working with clients/users as far as being able to login to the wifi and being put onto the proper VLAN.

I do want to use the FreeRadius -> Users -> MyUser -> Advanced Mode -> Simultaneous-Use to limit a users login to 2 concurrent logins but I set the limit to be 1 and I currently have 3 devices logged in as that user and working.

I am not sure what I have missed (I did enable SQL-Lite but that doesn't seem to help). Also is there a way to see the user that is connected to the IP address that was assigned via DHCP?

Hello,
Just wanted to update anyone. I got a list of all servers my provider uses and created an alias with them and then created a firewall nat rule to allow traffic from my providers servers to my PBX and everything including faxes now works properly.

Hello everyone,
I put in an OPNSense router and now my faxes have stopped working over VoIP.

I put my original router back in place and the faxes successfully send.

I am still very new to OPNSense so I am not sure where to start troubleshooting the issue.

Any guidance on how would be very much appreciated! I also searched the forums and the web and did not see any references to T.38.