"
Perfect
;)
Thank you.
Js
;)
Thank you.
Js
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Discussion / Re: Stuck to configure a Firewall Allowing only Nessus ( TCP 8834)
November 11, 2021, 01:50:32 PM #2
General Discussion / Stuck to configure a Firewall Allowing only Nessus ( TCP 8834)
November 10, 2021, 09:45:52 PM
Hello blue and red teams,
I'm new to OPNSense and I'm stuck to configure a rule to allow only destination port for Nessus ( TCP-8834), as many protocol, the source port is not fixed to a specific value so I need to put ANY .
My actions :
Protocol TCP
Src_port : Any
Dst_Port : Other ( 8834)
Unfortunatly, when I save OPN make a rule Src_Port ANY Dst_Port Any. ... not good at all. So, everything is open :-(
If I edit the rule, I have a DST_Port = ANY
I also tested with "Alias" Port, but it fails too.
Can you give me some advice ? Did I miss something ?
Js
I'm new to OPNSense and I'm stuck to configure a rule to allow only destination port for Nessus ( TCP-8834), as many protocol, the source port is not fixed to a specific value so I need to put ANY .
My actions :
Protocol TCP
Src_port : Any
Dst_Port : Other ( 8834)
Unfortunatly, when I save OPN make a rule Src_Port ANY Dst_Port Any. ... not good at all. So, everything is open :-(
If I edit the rule, I have a DST_Port = ANY
I also tested with "Alias" Port, but it fails too.
Can you give me some advice ? Did I miss something ?
Js
Pages1
