"
Have you found a feasible solution for this issue? I am facing with same problems. I just noticed that in pfsense you can set-up sending interface for syslog.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
21.1 Legacy Series / Re: syslog on WAN with Public IP not sending into IPSec even with NAT
November 09, 2021, 08:05:51 AM #2
21.7 Legacy Series / Syslog via IPSec or able to choose source interface
November 08, 2021, 02:32:22 PM
I have troubles setting up remote logging target as the target is accessible only via IPSEC.
Have tried different things:
1. set-up static route with LAN IP for a remote NW gateway, but has not been successful
2. manually add localip (xx.xx.xx.xx) to /usr/local/etc/syslog-ng.conf.d # cat syslog-ng-destinations.conf, but it gets overwritten when I restart the service from GUI.
Is there a workaround that would enable to set-up source ip/interface?
Can you please add "source address" option to GUI configuration similar as there one with "ping diagnostics"?
Thanks.
Have tried different things:
1. set-up static route with LAN IP for a remote NW gateway, but has not been successful
2. manually add localip (xx.xx.xx.xx) to /usr/local/etc/syslog-ng.conf.d # cat syslog-ng-destinations.conf, but it gets overwritten when I restart the service from GUI.
Is there a workaround that would enable to set-up source ip/interface?
Can you please add "source address" option to GUI configuration similar as there one with "ping diagnostics"?
Thanks.
Pages1
