Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - miso76

#1
Hello,

i am facing the same problem rsp. similiar so instead to open a new thread i will use this one.

I have 2 pfsense in failover and i configure the VLANs on each box. For some reason on the 1st the opt8 interface is missing but on the 2nd it is present.
So i have one VLAN X on different opt interfaces. so VLAN8 on the first at opt9 and on the 2nd on opt8 which cause problem.
If all opt interfaces were present i could change simply the order on the 2nd box but due one is missing i cannot fix it in this way.
When i create an assignment it create the opt interface always in order.

May i have to backup the interfaces on the first box adjust the XML file (IP´s) and restore the interfaces on the 2nd box to have it equal ?
Is there another way ?

Thanks in advanced

Best Regards

-> created another assignment and opt8 was present so i just have to change the order. solved by myselv thanks