Show Posts
1
High availability / Re: Virtual IP and vlan interface mismatch after performing a sync
« on: September 29, 2021, 04:00:47 pm »
Hello,
i am facing the same problem rsp. similiar so instead to open a new thread i will use this one.
I have 2 pfsense in failover and i configure the VLANs on each box. For some reason on the 1st the opt8 interface is missing but on the 2nd it is present.
So i have one VLAN X on different opt interfaces. so VLAN8 on the first at opt9 and on the 2nd on opt8 which cause problem.
If all opt interfaces were present i could change simply the order on the 2nd box but due one is missing i cannot fix it in this way.
When i create an assignment it create the opt interface always in order.
May i have to backup the interfaces on the first box adjust the XML file (IP´s) and restore the interfaces on the 2nd box to have it equal ?
Is there another way ?
Thanks in advanced
Best Regards
-> created another assignment and opt8 was present so i just have to change the order. solved by myselv thanks
i am facing the same problem rsp. similiar so instead to open a new thread i will use this one.
I have 2 pfsense in failover and i configure the VLANs on each box. For some reason on the 1st the opt8 interface is missing but on the 2nd it is present.
So i have one VLAN X on different opt interfaces. so VLAN8 on the first at opt9 and on the 2nd on opt8 which cause problem.
If all opt interfaces were present i could change simply the order on the 2nd box but due one is missing i cannot fix it in this way.
When i create an assignment it create the opt interface always in order.
May i have to backup the interfaces on the first box adjust the XML file (IP´s) and restore the interfaces on the 2nd box to have it equal ?
Is there another way ?
Thanks in advanced
Best Regards
-> created another assignment and opt8 was present so i just have to change the order. solved by myselv thanks