Messages

I've updated another router to the latest and am getting the same behavior; the WebGUI doesn't work properly when accessed over the VPN.  This is a change as it's worked in all previous versions!

Thank you, reboots did not fix it.  Turns out this behavior with the WebGUI is only when I'm accessing it over OpenVPN.  If I access it from a local machine it works fine.  Unsure why this changed!

Appears to be a WebGUI problem, I can SSH in, select option 12 to Update and it acts like it should, checks for an update and tells me there's nothing to do.  Hopefully the next update will fix this...

Also unable to reboot using the WebGui, press the button and nothing happens, have to use SSH. 

No repositories are listed under Firmware, Settings.  Same for Type.

I upgraded these routers from 23.7.?? downloaded on October 6th. 

Since updating 3 routers to 23.7.8_1, the WebGUI doesn't work properly over OpenVPN.  Nothing in the Firmware section will update (just spins), unable to reboot (clicking Yes at "Are you sure you want to reboot the system?" does nothing.)  2 of the routers are at new sites so I updated another that's been around for a couple years (and previously worked fine over the VPN connection) and get the exact same behavior.

Original text below -

These are 2 recently installed routers, need to install a Plugin so I updated them first.  After the update, I go to Firmware, Status and it just spins.  Rebooted, same thing.  The Firmware Log is empty.  Not sure where to look next...

I had the same problem installing 21.7 (APU2 and APU4 boards), finally tried selecting "Other Modes," then "Auto (UFS)," and it works fine.