Messages

Thanks for that idea mate.

I actually edited the conf XML file and put the values in manually.

I also looked at the code on GitHub to see how it works and there is probably a pull request I could do to fix it.

Cheers

Hi all,

My first time setting this up, but I write software for a living so I'm reasonably ok with technical help.

I set my WAN (which goes to the internet provider) to a non DHCP setup, my ISP can't provide it for some reason.

I enter my IP address *.*.*.201

Then Enter the new Wan IPv4 subnet bit count to 31.  The subnet should be 255.255.255.254.

I get the error:-

"You cannot set network address to an interface"

Any ideas?

Cheers

Clinton