Show Posts
1
21.1 Legacy Series / Can't set WAN interface subnet bit count to 31
« on: July 10, 2021, 12:59:54 am »
Hi all,
My first time setting this up, but I write software for a living so I'm reasonably ok with technical help.
I set my WAN (which goes to the internet provider) to a non DHCP setup, my ISP can't provide it for some reason.
I enter my IP address *.*.*.201
Then Enter the new Wan IPv4 subnet bit count to 31. The subnet should be 255.255.255.254.
I get the error:-
"You cannot set network address to an interface"
Any ideas?
Cheers
Clinton
My first time setting this up, but I write software for a living so I'm reasonably ok with technical help.
I set my WAN (which goes to the internet provider) to a non DHCP setup, my ISP can't provide it for some reason.
I enter my IP address *.*.*.201
Then Enter the new Wan IPv4 subnet bit count to 31. The subnet should be 255.255.255.254.
I get the error:-
"You cannot set network address to an interface"
Any ideas?
Cheers
Clinton