Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - jdrake4

#1
General Discussion / Re: Multi WAN dpinger not working.
October 03, 2025, 02:33:48 AM
Awesome!
Thank you so much, that was it!
Just for anyone else reading this i did a little experimenting and found anything < 4 bytes was dropped by my 5g provider. So it just did the default windows ping length of 32
#2
General Discussion / Multi WAN dpinger not working.
October 02, 2025, 06:14:26 AM
I have been using Opnsense for a number for a few years, but am no expert.
I have two WAN connections setup, (DSL and a 5g Wireless) and this was working fine for well over a year. in about the last month or so i noticed the 5g wireless was offline. The Monitor IP was 8.8.8.8 but i swapped it to 1.1.1.1 to make sure was not something weird with the other DNS monitor IP. The DSL monitor IP is now 1.0.0.1, the RTT delay is about 20ms on average. If I use a monitor IP the 5g connection the RTT shows like 17,000ms and the port goes offline.
If i disable gateway monitoring on the 5g gateway the port starts to work no real issues. I can even disable the DSL gateway and ping the monitor IP on a command line on a connected PC and my delay is about 30 to 50ms.

To do additional troubleshooting I moved to a different Ethernet port on the 5g gateway and configured another port on the opnsense box to make sure there is not some issue with the Ethernet port. i have also tried to configure the port as 1g full duplex and that has not helped. This all worked fine maybe a month ago, (possibly longer as it could have failed over to DSL and i would not have noticed it for a while). I also tried reinstalling Opnsense from USB and importing the backup and still no luck.

Any thoughts or ideas would be greatly appreciated.
#3
Update on Web GUI not working:
Looks like everything was broken.
  1.System would log start on Lobby--Dashboard Page
  2. Could not go to any Menu Pages like Reporting or System or Firewall Etc....
  3. Open Lobby--License, Then Menu pages will load like Reporting, System, Firewall Etc
  4. Open System--Firmware--Plugins
  5. I had a Orphaned Plugin os-dyndns, I deleted that

  6. Dashboard Loads Normal now
#4
I might have a similar issue. on 24.1_1 and Dashboard is not working.
It appears the whole web gui does not work. But if I go to Lobby--License page first, then I can go to the rest of the web GUI. If i go back to Dashbaord then it will not load.
I assume i have a bad widget that became obsolete in version 24. Just not sure how to fix that yet.