1
General Discussion / Re: Opnsense as bhyve guest freezes
« on: April 15, 2021, 10:05:36 pm »
Thank you.
I've migrated to opnsense now and everything seems to work.
I've migrated to opnsense now and everything seems to work.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Discussion / [Solved] Opnsense as bhyve guest freezes
« on: April 15, 2021, 12:59:51 pm »
Hi!
I'm running pfsense at the moment and I want to switch to opnsense, but the installation freezes with every version I've tried.
My hypervisor is bhyve on FreeBSD. The behavior is the same on both version 12.2 and 13.0.
More specifically it reached the point where it reports the SSL fingerprints and then freezes. Breaking with Ctrl-c does not work. I've tried with the 21, 20 and 19 branches of opnsense and they all display the same behavior. I've tested both the dvd and vga images.
I've also tried writing the nano image directly to the virtualmachine's drive via dd, but that exhibited the same behavior when it booted.
My hardware is an Intel Xeon E5-2620 v3 with 256GB of ram. The vm has 1 cpu and 1GB of memory. I've also tried with both more cores and more memory, but that didn't change anything.
I've tested using both bhyveload and uefi firmware for the virtualmachine.
I'm running pfsense at the moment and I want to switch to opnsense, but the installation freezes with every version I've tried.
My hypervisor is bhyve on FreeBSD. The behavior is the same on both version 12.2 and 13.0.
More specifically it reached the point where it reports the SSL fingerprints and then freezes. Breaking with Ctrl-c does not work. I've tried with the 21, 20 and 19 branches of opnsense and they all display the same behavior. I've tested both the dvd and vga images.
I've also tried writing the nano image directly to the virtualmachine's drive via dd, but that exhibited the same behavior when it booted.
My hardware is an Intel Xeon E5-2620 v3 with 256GB of ram. The vm has 1 cpu and 1GB of memory. I've also tried with both more cores and more memory, but that didn't change anything.
I've tested using both bhyveload and uefi firmware for the virtualmachine.
Pages: [1]