Messages

Also under endpoints tab - Allowed IPs - ensure you have both networks listed appropriately on each side. This is what is allowed to route over the tunnel.

A single client would work with only 1 entry listed. This is not appropriate for clients behind the opnsense.

Thank you! This was my mistake.

I just had to add my local net to remote sites allowed IP adresses.

Hi there,

I would like to connect my local opnsense to my remote opnsense using wireguard.
Successfully configured the remote site - all remote clients are reachable by using wireguard-client for windows.

Now I want to set up my local opnsense to use the same configuration - did so, wireguard seems to be connected and handshaking. I can even ping the remote clients by opnsense (interfaces / diagnoses / ping ... using wg0 interface). Just working fine.

By using a client in my local network, the remote clients are still unreachable.
WireGuard/wg0-interface firewall settings set on any/any

Dont know what to do. Using the Wireguard Windows Client is just working fine.