Messages

1

21.1 Legacy Series / Q: Anyone notice recently FQ_Codel shaper letting bursts through much better?

« on: May 12, 2021, 08:50:47 pm »

I'm wondering if anyone else has noticed this. Recently, I've noticed my FQ_Codel shaper being way better at letting bursts through. Before, with a 42 Mbps bufferbloat Codel setup, it would always keep my file sharing/uploading at 22-24Mbps if it went more then a few minutes. Now, I notice FQ_Codel and my OPNSense shaper allowing it to burst to 35-40Mbps while still keeping latency very stable.

Did anyone else notice significant improvements?

2

General Discussion / Different DUID for different WAN interfaces

« on: May 09, 2021, 08:17:11 pm »

Hello OPNSense,

I have a cable modem with 3 WAN interfaces. My cable provider allows me to pull 3 IPv4 WAN IPs and a /60 max on each unique DUID. I have two WANs connected to my OPNSense from the cable modem. I can pull one IPv4 on both, but I can't pull IPv6 for both since the DUID IPv6 identifier is the same.

Is there any way I can make the DUID different on one WAN interface and different on the other? One /60 is exceedingly not enough for me.