Messages

As soon as I posted my topic I remembered something and BAM...you beat me to posting my oversight.

I had setup a URL Alias for a rule at some point and completely forgot about it and didn't document it. That is what I get. Removed the alias and all is normal.

RESOLVED

Hello,

I am hoping someone can provide some insight into what is going on with Adguard Home or show me what I am missing.  I even uninstalled and reinstalled the Adguard Home plugin this morning to see if it may have been something with my install, but the same behavior returned with the default settings.

I have attached some screenshots.  It looks like localhost is just querying thousands of random domain names nonstop.  I was curious if localhost was Adguard itself or queries being originated from within Opnsense.  Either way, why would the systems be querying all of these random domains?

I appreciate the help!

Did you ever figure this out?  I am seeing the same thing!

Did you ever test this out?

Thank you so much! I knew I had to be looking over something obvious. I need to look at the documentation to see how I missed that.

Thanks again!

Hello,

I have a fresh install of 20.7 and am setting up Wireguard.  What I am noticing is that when I configure an endpoint in the GUI the config does not seem to be saved to the wg0.conf file.  I have tried removing the plugin and putting it back in, deleting the setting and starting over, etc. with no luck.

The Interface config is populated properly in the wg0.conf file, just not the Peer config.

When I go into the CLI and add the Peer config by hand to the wg0.conf file everything works fine.  I am able to connect from my phone without issue.  But when I go into the GUI and click save within the Wireguard area it overwrites the conf file and removes the Peer config, even though it is present within the GUI.

Any assistance would be greatly appreciated.  I am new to OPNsense but have been using Wireguard for a while.  Just trying to figure out what I am missing.

Thanks!