Messages

1

General Discussion / Re: Two subnets

« on: June 13, 2020, 02:27:09 pm »

I have tried all that but I should be doing something wrong because I can´t get it fixed. Thanks

2

General Discussion / Re: Two subnets

« on: June 13, 2020, 01:07:13 pm »

Any idea ?  Thanks !

3

General Discussion / Re: Two subnets

« on: June 13, 2020, 08:28:37 am »

Opnsense is already doing everything here from ppoe to dhcp, everything. I just want to use the bt smarthub 2 for the wireless part, and no double nat is involved here because the dhcp is disabled, the wireless client are receiving dhcp from opnsense within 10.x.x.x as the cable lan clients and are able to communicate within them is just that the Bt router do not allow you to assign a different subnet otherwise I just change and that's it, you can't. No bridge mode, you even can't disable the wan part of that router and all the time I can hear an small rely inside of the router trying to do ppoe.  But well that doesn't matter, the router take for it own interface web a ip within 192. and as I said you can't change that so just wanted to be able to access that interface within my main and only lan 10.x.x without the hassle of modifying my client dhcp for a few minutes and then reconfigure. I think that this should be easy peasy for this distro, i did it in the past but don't remember how to achieve that. Thanks for your help

4

General Discussion / Re: Two subnets

« on: June 12, 2020, 10:43:20 pm »

Thanks for replying.

I already tried that, but doesn´t work. No ping, nothing between one subnet to other.

5

General Discussion / Two subnets

« on: June 12, 2020, 09:44:48 pm »

Hello,

I hope you can help me please.

I have two interfaces, wan and lan. Lan subnet is 10.20.30.0.

I have a bt smart hub 2 that I´m not using anymore because now I use opnsense on Unraid with a quad nic and I would like to repurpose that router and all the wifi disk attached a wireless access points within my 10.20.x.x network.

The problem is BT do not allow you to modify the subnet, so I have to stick with the one configured 192.168.1.254. So I have disable the DHCP on this router and connected one of it lan ports to my switch and all the wireless devices are working getting DHCP from OPNsense within the range 10.20.X.X.

But as I can´t change the range on the BT router and the interface ( gui ) is on 192.168.1.254, is there any way I can access from my network on 10.20.X.X to this interface without having to configure for a few minutes one pc in the network to that subnet ? I know is just for a few minutes but I would like to be able to connect to that subnet without touching anything.

Thanks !