Show Posts
1
General Discussion / Sensei, issues with configuring
« on: June 11, 2020, 04:53:44 pm »
Im new here and have installed and working OPNsense on an old laptop, Im hoping someone can help me.
Ive installed Sensei and during the configuration, its asking me to select the 'Interface to protect by Sensei'.
With Deployment Mode set too Router (L3) no interfaces are displayed, if I change the the deployment mode to Bridge mode (L2) the WAN shows up in the list.
Any idea why no interfaces show in L3 mode.
I only have 1 WAN and 1 LAN interface.
It appears OPNsense is working ok as it is with the interfaces I have setup.
Regards
Ive installed Sensei and during the configuration, its asking me to select the 'Interface to protect by Sensei'.
With Deployment Mode set too Router (L3) no interfaces are displayed, if I change the the deployment mode to Bridge mode (L2) the WAN shows up in the list.
Any idea why no interfaces show in L3 mode.
I only have 1 WAN and 1 LAN interface.
It appears OPNsense is working ok as it is with the interfaces I have setup.
Regards