1
20.1 Legacy Series / Re: WAN DHCP release
« on: May 01, 2020, 05:09:08 pm »
Found it.
it's on the interfaces - overview
it's on the interfaces - overview
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
20.1 Legacy Series / WAN DHCP release
« on: May 01, 2020, 04:45:28 pm »
Hello.
I can't seem to find a WAN DHCP release selection when logged in via the GUI.
I have found, over the years, that quite often, if you don't issue a WAN DHCP release before swapping out firewalls, you can't reconnect to some timeout.
Yes, I know you can do Mac address copying, but I have found that also doesn't work.
In pfsense, from there is a shell I can get to and issue the command from there, but I don't see a shell option when I login remotely.
Any ideas ?
I can't seem to find a WAN DHCP release selection when logged in via the GUI.
I have found, over the years, that quite often, if you don't issue a WAN DHCP release before swapping out firewalls, you can't reconnect to some timeout.
Yes, I know you can do Mac address copying, but I have found that also doesn't work.
In pfsense, from there is a shell I can get to and issue the command from there, but I don't see a shell option when I login remotely.
Any ideas ?
3
20.1 Legacy Series / 2nd LAN fw config
« on: April 14, 2020, 10:17:12 pm »
Hello.
I'm new to opnsense. Looked at the docs and searched, tried some stuff that blocked my 2nd lan out so need some advice/guidance.
So I have a 4 port box. Works fine, Tested from outside and its stealthy.
Decided to create a 2nd LAN on my third port called 'remote' for remote working. At first it didn't work but on checking the FW for the first LAN and then the 2nd, saw it didn't auto create it. So, now 'remote' is working fine...but...
If I scan the first LAN from the new 'remote' one, I can see all the computers/devices.
How do I configure the new 'remote' to ONLY go out to the internet/WAN, and block it from seeing the original LAN ?
NOTE: I don't mind being able to NMAP from the first LAN to the remote LAN, but not the other way around.
Hit me with the clue stick please.
I'm new to opnsense. Looked at the docs and searched, tried some stuff that blocked my 2nd lan out so need some advice/guidance.
So I have a 4 port box. Works fine, Tested from outside and its stealthy.
Decided to create a 2nd LAN on my third port called 'remote' for remote working. At first it didn't work but on checking the FW for the first LAN and then the 2nd, saw it didn't auto create it. So, now 'remote' is working fine...but...
If I scan the first LAN from the new 'remote' one, I can see all the computers/devices.
How do I configure the new 'remote' to ONLY go out to the internet/WAN, and block it from seeing the original LAN ?
NOTE: I don't mind being able to NMAP from the first LAN to the remote LAN, but not the other way around.
Hit me with the clue stick please.
Pages: [1]