Show Posts
1
General Discussion / Bufferbloat help
« on: April 09, 2020, 05:21:29 pm »
I have followed this:
https://tofanos.com/gabri/?p=41
For the below Rules, which section do I want? Floating, etc?
In all the sections, the ones below in red are not in the latest firmware unless I am missing something.
Can someone give me some assistance?
Thank You,
Todd
– Go into the Rules Tab and add a new rule that is going to apply our traffic shaping on for the upload speed, and configure it as follow:
Enable: checked
Interface: WAN
Proto: IP
Source: 10.0.0./24 (it should be your LAN subnet)
Destination: Any
Target: WANup
Description: WANup
Anything else leave it as default
Click Save
Then create a new rule for shaping the download speed:
Enable: checked
Interface: WAN
Proto: IP
Source: 10.0.0./24 (it should be your LAN subnet)
Destination: Any
Target: WANdown
Description: WANdown
Anything else leave it as default
Click Save
Click Apply at the bottom of the section
https://tofanos.com/gabri/?p=41
For the below Rules, which section do I want? Floating, etc?
In all the sections, the ones below in red are not in the latest firmware unless I am missing something.
Can someone give me some assistance?
Thank You,
Todd
– Go into the Rules Tab and add a new rule that is going to apply our traffic shaping on for the upload speed, and configure it as follow:
Enable: checked
Interface: WAN
Proto: IP
Source: 10.0.0./24 (it should be your LAN subnet)
Destination: Any
Target: WANup
Description: WANup
Anything else leave it as default
Click Save
Then create a new rule for shaping the download speed:
Enable: checked
Interface: WAN
Proto: IP
Source: 10.0.0./24 (it should be your LAN subnet)
Destination: Any
Target: WANdown
Description: WANdown
Anything else leave it as default
Click Save
Click Apply at the bottom of the section