Messages

1

Virtual private networks / Re: Wireguard & Mullvad - I'm lost.....

« on: January 29, 2020, 09:08:32 pm »

Which network is LAN and what is the content of the Alias?

If you mean by Network interface it's Vtnet1, if not it's 192.168.1.1 otherwise

Content of alias is just a single host, and that's 192.168.1.144 which is my laptop that i use for the purpose of only testing atm (easiest way for me to verify by using the Mullvad tool to check that it's using the VPN tunnel)

2

Virtual private networks / Re: Wireguard & Mullvad - I'm lost.....

« on: January 29, 2020, 08:30:35 pm »

Here's the wg0 interface config, gateway setup, LAN rule and Outbound NAT rule

It's propably in LAN rule or Outbound NAT rule i've missed a certain setting.

3

Virtual private networks / Re: Wireguard & Mullvad - I'm lost.....

« on: January 29, 2020, 07:22:51 pm »

Can you post screenshots of local server instance and linked endpoint?

1. Create local instance with Mullvad settings, tick "Disable Routes" and under Advanced set Gateway "1.2.3.4"
2. Create endpoint (0.0.0.0, 1.2.3.4)
3. Link endpoint in local instance
4. Assign an Interface to WG, no IP config and lock it
5. Go to System : Gateways : Single, create a gateway, Interface WG, IP address of gateway 1.2.3.4, tick "Far Gateway"
6. Go to Firewall rules and set the stuff you want with gateway of WG.

It's not that hard to get this running

Hi! I've tried to follow your instructions as you've mentioned. But somewhere along the way there seems to be a problem , and i think it's due to Firewall rules.

I just cant seem to be able to push my specific client through the Wireguard Interface by using the Gateway.

I've tried to reach you through IRC but i guess we're on different timezones and just going past each other at this point

Hopefully i can get in contact with you somehow, cause i know it's propably a simple and small step that i've missed along the way!