Messages

Hello,

after Updating to 25.1.7 and Reboot the c-icap service is not starting. c-icap was updated to Version 1.8 with this release with the change in release notes "Move logging to syslog" and i get these errors in the c-icap log:

2025-05-20T13:40:10   Critical   c-icap   main proc, WARNING: Can not check the used c-icap release to build service clamd_mod.so   
2025-05-20T13:40:10   Critical   c-icap   main proc,   
2025-05-20T13:40:10   Critical   c-icap   main proc, WARNING: Can not check the used c-icap release to build service virus_scan.so   
2025-05-20T13:40:10   Critical   c-icap   main proc, Warning, alias is the same as service_name, not adding   
2025-05-20T13:40:10   Critical   c-icap   main proc, The line is: sys_logger.access !localserver   
2025-05-20T13:40:10   Critical   c-icap   main proc, Fatal error while parsing config file: "/usr/local/etc/c-icap/c-icap.conf" line: 32   
2025-05-20T13:40:10   Critical   c-icap   main proc, Error adding acl spec: !localserver.   
2025-05-20T13:39:25   Critical   c-icap   main proc, Error opening/parsing config file   
2025-05-20T13:39:25   Critical   c-icap   main proc, WARNING: Can not check the used c-icap release to build service clamd_mod.so

Removing the Entry sys_logger.access !localserver from the c-icap.conf file resolves the issue and i can start the service.
After reboot the line is automatically added and service is down again. What is the command to revert to the previous version, tried opnsense-revert -r 25.1.6 c-icap but it did not work. Thanks for your help.

No, test was against http.

Hello,

i installed my Opnsense 2 weeks ago with fresh install 19.7.5 and configured webproxy/clamav/c-icap with transparent Proxy with the following Documentation:
https://docs.opnsense.org/manual/how-tos/proxyicapantivirusinternal.html, Eicar Test was successful, file was blocked with .log entry in c-icap/clam.
Then i upgraded to 19.7.7 and disabled IPv6 following this guide https://www.thomas-krenn.com/en/wiki/OPNsense_disable_IPv6 now eicar blocking ist not working anymore. Changed nothing else. Access Log of proxy shows access, changing entries in c-icap and icap settings from ::1 to 127.0.0.1 does not work. Is icap Working with the ..1 entries if ipv6 is disabled ? Thanks for your help.

Regards Robert