Messages

Does anyone actually respond to the posts with any help?  Is there a better forum to post these questions / problems on to?

Does anyone actually respond to the posts with any help?  Is there a better forum to post these questions / problems on to?

I switched back to my RT-AC87R and I am now getting a consistent 300+ Mbps download speed.  The upload speed is the same on both the Asus router and the OPNsense firewall (about 23-25 Mbps).

I switched back to my ASUS RT-AC87R and everything is working correctly.  Would like to figure out what I have setup incorrectly on the OPNsense firewall.

I have just switched over to OPNsense from an ASUS router.  Right after boot up the speed test returns 360 Mbps download and 24 Mbps upload, then 10 minutes later the test returns speed of 5 Mbps download and 23.5 Mbps upload.  Additional tests return similar numbers.  Reboot the OPNsense and download speed increases back to normal, but then decreases down to 5 Mbps.

Versions    OPNsense 19.7.7-amd64
                FreeBSD 11.2-RELEASE-p16-HBSD
                OpenSSL 1.0.2t 10 Sep 2019

Any advice would be appreciated

I just switched over to a OPNsense from an ASUS router.  Everything was working fine before the switch over.
I have 1 PC running windows 10 that is setup as a Plex Media server, an FTP server and I use remote desktop to connect to administrate it when I am not local.

Everything works correctly on the LAN, but nothing works coming in over the WAN connection.

My OPNsenser firewall is on the LAN at 192.168.1.3 and the Plex / FTP server is on the LAN at 192.168.1.10

OPNsense server info:
Versions:    OPNsense 19.7.7-amd64
                  FreeBSD 11.2-RELEASE-p16-HBSD
                 OpenSSL 1.0.2t 10 Sep 2019

I have checked the ports using CanYouSeeMe.org and I am getting an error message for all ports.

I am forwarding the following ports: 32400 (Plex), 21 (FTP) & 12345 (RDP, redirecting to 3389 internally)

PS. #1) Shouldn't I be able to check the WAN connection from the LAN? (I thought that is what the NAT reflection option was for)

PS. #2) Is there a way to see if OPNsense is denying the requests? (A log or monitoring tool)