"
Well, I reload the OPNsense from previous snapshot and configure the PPTP again now it is working.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
19.7 Legacy Series / OPNsense PPTP not working
October 04, 2019, 07:26:41 PM
Hi,
My ISP provides me internet link on WAN cable over PPTP. So I get my public IP from PPTP and ISP WAN IP directly from DHCP. Currently I have Tenda router which is in front of OPNSense on WAN Side which acquire this public IP and WAN IP. I tried to use ISP WAN cable directly with Opnsense and bypassed the Tenda router. I get public IP and WAN IP on OPNsense but I cannnot use internet. Trace route just reach to OPNsense and then timeout. Policies and gateway are configured. I searched the logs and found out one constant log.
Under System general logs kernel: loop detected on pptp1
Regards,
Nabeel
My ISP provides me internet link on WAN cable over PPTP. So I get my public IP from PPTP and ISP WAN IP directly from DHCP. Currently I have Tenda router which is in front of OPNSense on WAN Side which acquire this public IP and WAN IP. I tried to use ISP WAN cable directly with Opnsense and bypassed the Tenda router. I get public IP and WAN IP on OPNsense but I cannnot use internet. Trace route just reach to OPNsense and then timeout. Policies and gateway are configured. I searched the logs and found out one constant log.
Under System general logs kernel: loop detected on pptp1
Regards,
Nabeel
Pages1
