Messages

Resurecting this as I have tried playing with Powerd some more.

With Powerd enabled and set at Adaptive, my cpu temperateres are higher than when I disable Powerd (Powerd off and Powerd set to Minimum seem to be the same).
Is that normal/correct?

Using command Powerd -v in ssh, I can see the cpu goes to 1001MHz (base clock +1MHz)  regardless if Powerd is on or off.
I was expecting temps to be higher with Powerd off so just curious.

Thanks

It does but why have a guide that  then links to another guide that repeats setting up the interface and peer?
Its a bit confusing.
I wanted to make sure I was reading it correctly before continuing.

If I want all traffic routed through the vpn, do I have to set up selective routing?

Thanks for your help

Thanks for your reply.

By step 6, do you mean https://docs.opnsense.org/manual/how-tos/wireguard-selective-routing.html
It seems to repeat setting up the Instance and Peer again from the previous Road Warrior guide?

Maybe more info will help me get a reply.

I want to set up a router on a subnet and route all traffic for devices connected to it, via my Proton Wireguard vpn.
I can set up the instance and peer in Wireguard.
Not sure what to do after that.

Help or a guide would be appreciated.

I am trying to set up OPNSense to route all traffic through a vpn via Wireguard.

I created a peer and an instance via this guide https://docs.opnsense.org/manual/how-tos/wireguard-client-proton.html
After enabling Wireguard in step 5 if I look in OPNSense at VPN>Wireguard>Status, I see the instance says up under Status but no handshake while the peer does not say up but shows a handshake.

Not sure what to do next as the guide says to setup Selective routing which Im not sure thats what I need if Im routing all traffic through the vpn.

Thanks for any advice

I have OPNsense 19.1.9-amd64 running on a Zotac Z Box with a Celeron N4100 cpu which can scale up to 2.4Ghz.
The Dashboard shows N4100 CPU @ 1.10GHz (4 cores) but does not show any speedstepping above 1.1GHz.

Is there a way to force speedstep or check if it is working?

I am a Linux newb so please answser like you are talking to an idiot (which you kind of are)  :)

Thanks for your help