"
TY
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / Multi WAN question
May 17, 2019, 09:29:54 AM
Hello,
i would like to switch to OPNSense. The only thing that i couldn't find in the documentation is a Multi WAN question.
I only see LoadBalancing / Failover in the documentation. But is it possible that i split up 2 LAN and 2 WAN line to each other without failover / Load Balancing? So that LAN1 uses only WAN1 and LAN2(&3) only uses WAN2. Is that possible? i assume it is wenn i do configure Manual NAT for all the Networks. But before i try i just wanted to know if it is possible.
Thanks
i would like to switch to OPNSense. The only thing that i couldn't find in the documentation is a Multi WAN question.
I only see LoadBalancing / Failover in the documentation. But is it possible that i split up 2 LAN and 2 WAN line to each other without failover / Load Balancing? So that LAN1 uses only WAN1 and LAN2(&3) only uses WAN2. Is that possible? i assume it is wenn i do configure Manual NAT for all the Networks. But before i try i just wanted to know if it is possible.
Thanks
Pages1
