Messages

https://imgur.com/a/hRUHPt2
Is my interfaces and some of the rules I have tried to use to no avail.

I have used the 19.1 guide to setup NordVPN on my 19.7 setup.
I have set this up for LAN, and am able to browse the net behind my VPN.

Now, I would like to allow the Wireless to connect through VPN, AND Wireless and Lan to talk to each other.

I cannot figure out what rules I would need to setup for this.

Any ideas?

I am losing my mind.
I have tried so many combinations of possibilities, that it is impossible that I havent stumbled on the correct solution.

I have a Dell poweredge T420 Server. Bunch of Nics in it, disabled ALL but the onboard nics, and uplugged everything BUT the WAN cat6, from the modem.

No matter what I do, I cannot get it to get a DHCP4 address from WAN.
I cannot reach it on any internal ip, bridge, virtual internal network from another machine, nothing. NOTHING.

I need help and feel like a failure for not being able to setup my home network. I dont get this.

I am losing my damn mind. I reset EVERYTHING back to factory.  redid the image to the hdd. started from scratch.

This time, I cannot import my VPN Cert information, says
The field Key data is required.

I swear someone is messing with me, just trying to crush my spirit.
Reset EVERYTHING to get back to square one, and now cant even get the vpn tunnel up.

I have had nothing but trouble with this. The other one worked NO PROBLEMS.

the VPN interface is up. its a stupid rule somewhere. I dont get it. so frustated and discouraged.

I have been struggling for weeks.
Have broke a laptop throwing it across the room, and have essentially broken my fist.

I am at my wits end.
OPT1, all traffic needs to go over VPN_DHCP. every rule I have tried does not work. ONLY opt1. thats it. It shouldnt be this hard.