Messages

Good timing.  Was not working under 18.7, until I wiped and reinstalled, then it did work (never figured out what the problem was).  However, I have since updated to 19.1 and it's failing again.  This time however, I get an error message:

Code Select Expand

kernel: ath0: stuck beacon; resetting (bmiss count 4)

I'm not sure how to enumerate the PCIe slots, but viewed from the front it's the far-right slot.

I created an OPNSense VM in XenServer.  One external network connection, one internal host-only, so OPNSense can route other VMs.  The firewall refuses to allow anything over the internal NIC.

pfSense, installed in exactly the same manner, works.

Any idea if this is a bug, or if there is a configuration step I missed?

Hello OPNSense,

I've got a PCEngines APU2 with a WLE200NX wifi card (Atheros AR9280).  I've switched from pfSense to OPNSense, and while I like some of the changes, I can't get the card to run as an AP.  This worked perfectly under pfSense.  Here's what I've tried so far:

- 2.4 n and 5 na (not simultaneously)
- WME on
- WPA2, AES, Open Shared, Passphrase
- most other settings auto or default
- regulatory domain FCC/Canada/Indoor
- no IP set on this interface, interface is bridged, other members of the bridge work perfectly

With pfSense, the same setup with the same hardware worked.  What happens now:

- OPNSense accepts all the parameters, saves, applies
- SSID is broadcast
- clients attempt to connect, but never succeed
- no client error messages so far (not sure why not)

If anyone knows what's up, that'd be great.  Failing that, a pointer to the correct log file(s) will let me run the setup a few times and post the results.