Messages

1

General Discussion / Re: OPNSense in Virtualbox, can't access webgui

« on: November 05, 2018, 03:59:44 am »

Is there something I have to enable in Win10 to get the networks to see each other? The Windows firewall is disabled, I don't have any AV installed beyond Windows Defender. I can't for the life of me get my VM to even get a WAN IP. I've tried creating two host networks and bridging one with my ethernet connection. I've tried all of the VM Network settings and literally nothing works. At one point I did get a WAN IPv6 address but I have no idea where that even came from and I couldn't access it after I disabled the Opnsense firewall.

2

General Discussion / Re: OPNSense in Virtualbox, can't access webgui

« on: November 03, 2018, 02:00:54 am »

Do you know if there's anything else I have to do to get the IP's to pass through correctly? I followed the guide (https://linoxide.com/firewall/install-opnsense-virtualbox/) and I just can't get it to work. I've even changed it to the same subnet as my main network, using unused IP's

Here's all the settings:
https://imgur.com/a/uHq1Eug

3

General Discussion / Re: OPNSense in Virtualbox, can't access webgui

« on: November 02, 2018, 09:13:54 pm »

So if I change the host IP to 192.168.20.2 then it should work or do I need it on a different subnet?

4

General Discussion / OPNSense in Virtualbox, can't access webgui

« on: November 02, 2018, 04:22:59 pm »

https://imgur.com/a/uvVM7vK

Did I do something wrong with this setup? I can't for the life of me access the gui, but I can ping it.