Messages

Just got OPNSense configured on a standalone box. Running 18.7.4 at the moment.

I am unable to see my ESXi box on the lease list or the ARP table. I have the ESXi box statically set to an IP, and i can hit it from vShpere client using the assigned IP just fine. And any VM that i spin up gets assigned an IP which i can see via lease list or ARP table.

Why does the esxi box interface IP not show up in any list on OPNSense?

It assigned 0.9

I had given it 0.150. But before i assigned it i verified that nothing on the network had that IP assigned or reserved. So im not sure how there could of been a conflict.

Got it thank you.

I re-enabled the WAN and LAN interfaces. Then let the LAN interface be assigned via DHCP while leaving the WAN interface disconnected. Once an IP was assigned i could ping and hit the GUI.

Im still a little confused why allowing the IP to be assigned via DHCP I was able to connect, but if i tried to set a static LAN IP, i get nothing?

New install of 18.7 on stand alone device. Assigned an interface and IP to LAN only.

I am unable to ping or access the GUI using the assigned IP. Just getting time out requests when I ping. The IP is on the same subnet (192.168.0.0/24) as the rest of my network. I have no VLANs set at the moment and i have the device plugged directly into my switch for the time being so i can set it up and get familiar with the GUI before i deploy it in my network for real.


Thank you for any help anyone can provide.