Messages

Thank you!

What a horrible way to work through remote IP networks but they are all there.

You're a star!

I am using OPNsense to terminate multiple aggressive IPsec IKE v1 tunnels from legacy devices connected on dynamic IP addresses.

Each device has a unique phase 1 (password) and phase 2 (remote subnet) entry.  Previously (21.7) they were paired in the GUI with each phase 2 listed under the unique phase 1.

Since 22.1, the phase 1 and phase 2 are separated, however, there is a bug where the (25 entries in my case) phase 1 entries are shown but only 1 of the matching 25 x phase 2 entries are shown.

If I look in the backup XML I can see all the 25 x phase 2 entries correctly.

Is there a way to roll back the interface to the older style?

Is this a bug?

I am running 18.7 and having the same issue as to where I activate the user.

Did you find an answer to this?  I can only guess it has moved but I have no idea where.