Show Posts
1
22.1 Legacy Series / [SOLVED] Bug? - VPN: IPsec: Tunnel Settings not displaying more than 1 Phase 2
« on: April 26, 2022, 03:33:11 am »
I am using OPNsense to terminate multiple aggressive IPsec IKE v1 tunnels from legacy devices connected on dynamic IP addresses.
Each device has a unique phase 1 (password) and phase 2 (remote subnet) entry. Previously (21.7) they were paired in the GUI with each phase 2 listed under the unique phase 1.
Since 22.1, the phase 1 and phase 2 are separated, however, there is a bug where the (25 entries in my case) phase 1 entries are shown but only 1 of the matching 25 x phase 2 entries are shown.
If I look in the backup XML I can see all the 25 x phase 2 entries correctly.
Is there a way to roll back the interface to the older style?
Is this a bug?
Each device has a unique phase 1 (password) and phase 2 (remote subnet) entry. Previously (21.7) they were paired in the GUI with each phase 2 listed under the unique phase 1.
Since 22.1, the phase 1 and phase 2 are separated, however, there is a bug where the (25 entries in my case) phase 1 entries are shown but only 1 of the matching 25 x phase 2 entries are shown.
If I look in the backup XML I can see all the 25 x phase 2 entries correctly.
Is there a way to roll back the interface to the older style?
Is this a bug?