Messages

This is exactly what I was looking for!

Thanks, Frank!

Hi all,

Is it possible to disable "Automatically generated rules" logging? Especially "let out anything from firewall host itself". I can't find how to disable it via GUI.

Thanks in advice!

As I understand, vnstat is not getting values automatically by interface speed, they coded in vnstat.conf under "MaxBandwidth" value.
The firewall is simply local firewall, no IPS or other prevention/detection tools are enabled. A few plugins related to monitoring and reporting are enabled.

Hi folks,

I'm running to issue related to throughput. I have Vmware with 10G interfaces and they are configured as vmx devices. Under interfaces configurations status of interfaces show "media: Ethernet autoselect" nothing mentioned about speed. Iperf results show that interfaces acting as they would be 1G, as speed results are no more than 800Mbps. I did tests between other guest hosts and speed is around 8Gbs.
Is there any command to check speed of interfaces in OpnSense? 
Is there an option to force 10G? Or it's possible that something else is reducing speed?
No traffic shaper or limiter configured in OpnSense, but vnstat is reporting an error: "vnstatd[59722]   Traffic rate for "vmx0" higher than set maximum 1000 Mbit (30s->4010803200, r7814958089 t295405005, 64bit:1), syncing".

Thanks in advice!