"
Thank you so much.
Disabling reply-to on WAN rules did the trick.
:)
Disabling reply-to on WAN rules did the trick.
:)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / [SOLVED] Unable to access WebGUI via WAN interface
June 04, 2018, 08:36:28 PM
I have a fresh 18.1 install that I'm testing. It's currently on my private network with an RFC1918 DHCP-assigned WAN address.
Problem is, despite enabling access from WAN Net, and removed the Interface's restriction on RFC1918 sourced addresses, I cannot access the installation's WebGUI via the WAN interface. Even if I enable very permissive pass rules, I still seeing Default Deny rule hits from WAN Net addresses in the firewall log. I see the WAN's MAC address in other hosts' ARP tables, but I'm not getting echo replies, or access via the WebGUI on TCP:443.
I can ping out from the interface with no problem.
Ideas welcome! Many thanks.
Problem is, despite enabling access from WAN Net, and removed the Interface's restriction on RFC1918 sourced addresses, I cannot access the installation's WebGUI via the WAN interface. Even if I enable very permissive pass rules, I still seeing Default Deny rule hits from WAN Net addresses in the firewall log. I see the WAN's MAC address in other hosts' ARP tables, but I'm not getting echo replies, or access via the WebGUI on TCP:443.
I can ping out from the interface with no problem.
Ideas welcome! Many thanks.
Pages1
