"
Hi,
I'm testing OPNSense to replace my actual firewalls (not the one connected to the internet but between my public network and internals networks).
I have some trouble with pfsync setup.
Master interfaces configuration :
WAN : 84.XX.YY.ZZ/26
LAN : 172.16.10.110/24 (GUI access)
INTERCONNECTION : 10.0.0.1/16
I configured Carp and PFsync on my master and created one interface on both firewall for the interconnection.
And after the reboot (mandatory to enable the config), I lost my GUI access and the INTERCONNECTION interface disappeared. Moreover the LAN netmask change from /24 to /32.
I tried to reconfigure the LAN interface using the OPNsense CLI but the netmask is always ignore .
Start
Config
End
PS : No IP problem with my slave firewall
Any idea ? ???
I'm testing OPNSense to replace my actual firewalls (not the one connected to the internet but between my public network and internals networks).
I have some trouble with pfsync setup.
Master interfaces configuration :
WAN : 84.XX.YY.ZZ/26
LAN : 172.16.10.110/24 (GUI access)
INTERCONNECTION : 10.0.0.1/16
I configured Carp and PFsync on my master and created one interface on both firewall for the interconnection.
And after the reboot (mandatory to enable the config), I lost my GUI access and the INTERCONNECTION interface disappeared. Moreover the LAN netmask change from /24 to /32.
I tried to reconfigure the LAN interface using the OPNsense CLI but the netmask is always ignore .
Start
Config
End
PS : No IP problem with my slave firewall
Any idea ? ???
