Messages

1

19.7 Legacy Series / Re: Issues with automatic outbound NAT

« on: December 08, 2019, 04:14:09 am »

I have conclusively found the issue with automatic outbound NAT has not yet rectified. Below is part of the firewall changes done to 19.7.3. This has either broken again or not properly fixed in the first place.


list of changes from 19.7.3
firewall: restore automatic outbound NAT pre-19.7 behaviour which excludes gateways not configured and not dynamic


Can someone add this to the list of bugs that needs to be fixed?

2

19.7 Legacy Series / Re: Issues with automatic outbound NAT

« on: December 06, 2019, 09:49:51 pm »

Anyone??

This outbound NAT issue is hindering my deployment across 5 networks.

3

19.7 Legacy Series / Re: Issues with automatic outbound NAT

« on: December 01, 2019, 11:00:44 pm »

I have this exact issue. Just started my move from pfsense to opnsense. For a good 2 hours I went through multiple settings troubleshooting what was blocking the layer3 network from communicating out of the WAN. This was never an issue with pfsense which I have used for over a decade.

Is this intended? I see the layer3 network in the autocreated networks but it not updating or reflecting the same on the NAT outbound. I have to select hybrid mode and add the subnets from the internal network.