Messages

Thanks for the link! Using an alternative ip address per new gateway as you suggested has allowed me to use multiple clients successfully.

Normally in the Single Gateway address box? I've attached the screenshot to show that doesn't work. Unless I've done it wrong.

I'm in the process of switching from OpenVPN Clients to WireGuard Clients on OPNsense. After an arduous day of trying, I have successfully managed to get the first client to work.

I manually set the Gateway to 10.100.0.1 (ip address on the VPN provider's server) in the WireGuard local configuration, and added a single 'far gateway' with that same address to the new interface for the WireGuard client which now routes perfectly.

However, I tried to set up a second client for a different country with the same VPN provider without success. when I added another new interface, then tried to attach a new gateway to that, I get the following error :

The following input errors were detected:
The gateway IP address "10.100.0.1" already exists.

Both client configurations I have been given use exactly the same gateway address. Is there a way to resolve this issue?

Any update as to if anyone can get this working?  I have 18.1.2_2 installed, just setting up the configuration, I have followed the instructions and the vpn clients connect successfully, however when I try to connect a host to them, web pages don't load.

I also noticed, when switching the NAT outbound rules to manual, the automatic ones disappear. Is this supposed to happen? On the previous version it used to leave the standard WAN interface rules there which made things easier.