Messages

1

17.7 Legacy Series / Re: IPSEC Site to Site VPN

« on: September 19, 2017, 05:57:03 pm »

Ok. So i am half way there. I can ping from one side of the Tunnel but not the other.

Site A

Ping 192.168.4.0 Reply Timed Out from 192.168.1.0

Site B

Ping 192.168.1.0 Reply Received from 192.168.4.0

Any ideas? I have checked the config on both OpnSense servers and they are the same. I must be missing something as the Tunnel is up and can ping from one site.

Any ideas?

2

17.7 Legacy Series / Re: IPSEC Site to Site VPN

« on: September 19, 2017, 05:28:52 pm »

Scrap the above message. I though this was working but its not.

3

17.7 Legacy Series / Re: IPSEC Site to Site VPN

« on: September 19, 2017, 04:47:41 pm »

Ok, So i have this working.

On the Phase 2 setup. The Local Network was set to LAN Net as per the documentation. What i have done is change this from LAN Net to Network and specified the LAN Subnet.

Example

Local Network
Type = Network
Address = 192.168.1.0/24

Remote Network
Type = Network
Address = 192.168.4.0/24

I can now see both networks from both sides.

Thanks again for your time to reply earlier.

4

17.7 Legacy Series / Re: IPSEC Site to Site VPN

« on: September 19, 2017, 01:44:27 pm »

Thanks for the replies chaps.

I have added multiple subnets to the Phase 2 but the issue i am facing is that none of them work apart from the subnet that the OpnSense servers are on.

Craig

5

17.7 Legacy Series / IPSEC Site to Site VPN

« on: September 19, 2017, 11:46:19 am »

Hi Guys.

Hope someone can push me in the right direction. I have two OpenSense servers at two separate locations. for example i have

Site A
Subnet 192.168.1.0
Subnet 192.168.2.0
Subnet 192.168.3.0

Site B
Subnet 192.168.4.0
Subnet 192.168.5.0
Subnet 192.168.6.0

Now i have followed the example in the Wiki see. https://wiki.opnsense.org/manual/how-tos/ipsec-s2s.html?highlight=vpn

I can start the VPN and i can pass traffic from 192.168.1.0 to 192.168.4.0 back and forth. Is there something i am missing to allow multiple subnets to be used as part of Phase 2?

Please let me know if you require any more info from me.

Thanks in advance.

6

17.7 Legacy Series / Re: VMware ISO download

« on: September 13, 2017, 08:14:14 am »

Thanks guys. Got the ISO now.

7

17.7 Legacy Series / [SOLVED] VMware ISO download

« on: September 12, 2017, 04:42:01 pm »

Guys.

I really want to give OPNSense a blast and hopefully move away from PFSense. On the downloads page I am downloading the DVD but its coming down with a .bz2 extension and not ISO. Am i missing something here or so i need to grab the ISO from another location?

Thanks in advance