Messages

Ok. So i am half way there. I can ping from one side of the Tunnel but not the other.

Site A

Ping 192.168.4.0 Reply Timed Out from 192.168.1.0

Site B

Ping 192.168.1.0 Reply Received from 192.168.4.0

Any ideas? I have checked the config on both OpnSense servers and they are the same. I must be missing something as the Tunnel is up and can ping from one site.

Any ideas?

Scrap the above message. I though this was working but its not.

Ok, So i have this working.

On the Phase 2 setup. The Local Network was set to LAN Net as per the documentation. What i have done is change this from LAN Net to Network and specified the LAN Subnet.

Example

Local Network
Type = Network
Address = 192.168.1.0/24

Remote Network
Type = Network
Address = 192.168.4.0/24

I can now see both networks from both sides.

Thanks again for your time to reply earlier.

Thanks for the replies chaps.

I have added multiple subnets to the Phase 2 but the issue i am facing is that none of them work apart from the subnet that the OpnSense servers are on.

Craig

Hi Guys.

Hope someone can push me in the right direction. I have two OpenSense servers at two separate locations. for example i have

Site A
Subnet 192.168.1.0
Subnet 192.168.2.0
Subnet 192.168.3.0

Site B
Subnet 192.168.4.0
Subnet 192.168.5.0
Subnet 192.168.6.0

Now i have followed the example in the Wiki see. https://wiki.opnsense.org/manual/how-tos/ipsec-s2s.html?highlight=vpn

I can start the VPN and i can pass traffic from 192.168.1.0 to 192.168.4.0 back and forth. Is there something i am missing to allow multiple subnets to be used as part of Phase 2?

Please let me know if you require any more info from me.

Thanks in advance.

Thanks guys. Got the ISO now.

Guys.

I really want to give OPNSense a blast and hopefully move away from PFSense. On the downloads page I am downloading the DVD but its coming down with a .bz2 extension and not ISO. Am i missing something here or so i need to grab the ISO from another location?

Thanks in advance