Messages

1

General Discussion / Re: Access via WAN for remote access - not working, ideas?

« on: April 04, 2017, 07:36:50 pm »

Bart,

Very much appreciate the answer.   Makes total sense.   Essentially helping prevent someone from making a vulnerability.   I will go the VPN route.

Again, Thank you!

Casey

2

General Discussion / Access via WAN for remote access - not working, ideas?

« on: April 04, 2017, 04:03:57 am »

I have a firewall rule to allow WAN 443 thru to the WAN address to 443.   I have the web access set to https.   When I check the firewall logs, I can see that I'm allowed in to the to the WAN IP and not blocked.   However, I never get the GUI web page to respond.   I have also tried http/80 and Icmp.   With Icmp I do get replies when I have the rule active.

I know it's frowned upon to access remote this way but just getting accustomed to this vs pfsense now.

Trying to better understand.   

I also have the antilockout rules and the GUI port redirect disabled.

I tried a custom port as well 9090.


Any ideas what I could be missing?   I feel it must be something simple.   

What could I be missing?   I see the traffic at least passing thru the firewall rule to the WAN address.