Messages

I figured it out last night.  I had to allow traffic to my VLAN gateway IP address first. 

Proto   Source            Port     Destination   Port   Gateway         
IPv4 *   USVPN net         *    192.168.1.1    *        *
IPv4 *   USVPN net         *         *               *        VPN_WAN_DHCP

[Proto Source Port Destination Port Gateway]

Hi there,

I'm trying to setup a VPN client on my router and can't get it working.  I see the traffic going out but no traffic able to route back. 

I had a rule in my firewall that routed all traffic to the VPN gateway instead of the default gateway.  I decided to just set the override to my default gateway to see what's happening and I can't get that working either, trying to determine if there is an issue with entering any value in the gateway field.

This is what works because it goes through the default gateway:

Proto   Source            Port     Destination   Port   Gateway        
IPv4 *   USVPN net         *         *                  *        *

This doesn't work even though it is pointing to the same gateway. 

Proto   Source            Port     Destination   Port   Gateway 
IPv4 *   USVPN net         *         *                  *        WAN_DHCP

There are currently no other rules because I just want to establish connectivity first before locking it down.  WAN_DHCP is my default gateway, so I would assume they should both work.

Any ideas? 

Yes, they are using OPNSense as the default gateway.... actually, they do not.  This is what happens when you try doing this at 2 in the morning.  The hosts I am trying to connect to are not using DHCP and their gateways were never updated.  Thank you very much.

Hello everyone,

I have just installed OPNSense for the first time yesterday.  I followed the "SSL VPN Road Warrior" setup and can connect via my iPhone through the openVPN app.  When I check my public IP all traffic is being routed through the opnsense server so all is good.  The problem is that I cannot access anything on my LAN other than the opnsense server through the private IP.  When I check the firewall logs, traffic is being passed to the local addresses, but I dont get a response and no blocks in my logs.  What am I doing wrong?