Messages

I am not looking to pick a fight here.  It's really pretty simple, opnsense either uses hidden/default rules or it doesn't (neither good or bad).  For my own personal edification, it is something I would like to know. 

It is not uncommon for firewalls to use this type of architecture.  Since opnsense is a fork of pfsense it would make sense that was carries over into opnsense. 

All I am asking for is a simple confirmation or denial, and if they are using default/hidden rules, what are they?

What are the "hidden rules" installed when the "default settings are applied" ? Doesn't a "default" install of OPNsense default install with "default/hidden" rules?

If it does, what is that rule set, and how/where can I view them?

Because it's s fork.....|  | |
                               |_|_|   
                                  |
                                  |
                                  |

-M

Where/how can I view (show) the default/hidden rules?  I have searched high and low.  Am I missing it?

-M