Topics

Greetings, I sincerely hope you're all well under the circumstances.

For the life of me, I've got 2 (public) internet facing interfaces + 1 "LAN" interface and of course, "LAN" traffic is routed through the "WAN" interface. But for a few "LAN" hosts, I want to force traffic going out to the public internet to go through the second, "OPT1" public interface.

What I've tried so far, "firewall" -> "NAT" -> "Outbound" -> "hybrid mode" -> "manual rules"  and then created a rule for each "LAN" ip address affected plus "interface" field and "NAT address" to "OPT1". Still, the "LAN" hosts report to have public addresses of the "WAN" interface, not the "OPT1" one.

Much appreciated if you drop me a line. Long live OPNSENSE! Thank you.

Thank you for reading this. I know this may sound stupid, BUT, just to check with you guys if the plugin is currently expected to work properly.

As far as I can go is:

ACCOUNT_THUMBPRINT=, Calc CA_KEY_HASH=, _accUri=,

" Registered " and " code='201' "

Then no certificate seems to be issued.

Thank you.

Greetings! Thanks for reading this.

I'm looking for that < ipmitool > command line application that I'm used to on my *nix management workstations. < ipmitool > allows for management of IPMI capable hardware such as " on/off switch ", a much better solution than " WoL ".

Anybody out there knows how to find the same package for installation into OPNSense? Please bear with me if it seems too stupid.

Much appreciated. Thank you.