1
General Discussion / Problem with my new setup
« on: May 19, 2016, 12:23:47 am »
Hello,
I am currently in the process of setting up an old firewall to use with Opnsense. I boot via USB and install to my ssd via Console. Everything checks out so far and looks format and write to the selected drive with no problems. As soon as it gets to the part to remove the USB drive and reboot it won't boot from my SSD.
I've re-installed several times and ran into the same problem. It continues a boot loop until I insert the USB drive I used, then it will bring up the installation option again.
Is it for some reason installing to the USB key instead of the SSD? Thats the only thing I can think of right now but see no reason it shouldn't work, as there are no errors when writing/formatting to the SSD.
Any help is appreciated.
Thanks.
I am currently in the process of setting up an old firewall to use with Opnsense. I boot via USB and install to my ssd via Console. Everything checks out so far and looks format and write to the selected drive with no problems. As soon as it gets to the part to remove the USB drive and reboot it won't boot from my SSD.
I've re-installed several times and ran into the same problem. It continues a boot loop until I insert the USB drive I used, then it will bring up the installation option again.
Is it for some reason installing to the USB key instead of the SSD? Thats the only thing I can think of right now but see no reason it shouldn't work, as there are no errors when writing/formatting to the SSD.
Any help is appreciated.
Thanks.