Topics

Hi,
I have configured openvpn client and it manages to connect.
However, i get this error:
GDG6: problem writing to routing socket: No such process (errno=3)

I dont think it has to do with the vpnclient configuration...I have tried to tick the option " Don't add/remove routes".
When this option is activated, my internet gets blocked.
I get the error wether i tick the option or not.
I have tried to sepcify interface : any or interface : wan and it's the same.

Do i need to do something specific in the system administration so it works properly?

Hi,
I have this setup on my lan network where i allow traffic out on ports 22, 53, 80, 123, 443.
Then I block all traffic out on any ports
Then I allow all traffic in.
I have tried to send an email with python using smtp lib on port 587.
It was being blocked before I opened port 587 on my internet box. But after i open port 587 on my internet box it was not blocked anymore, as if the firewall let it pass.
What did i do wrong on my firewall lan rules?
See the attached screenshot for details.
Thank you

Hi,
I have found this tutorial https://support.nordvpn.com/Connectivity/Router/1292598142/OPNsense-19-1-setup-with-NordVPN.htm
I dont understand why I have to add an opt1 interface named NordVPN.
On my hardware i have 3 interfaces and i cant add a nordvpn interface...
In the tutorial when configuring openvpn client, interface is set to any so i guess all interfaces will use the openvpn client...all the rest of the tutorial is about configuring dns on the specific interface.
Should i just link the unbound DNS to my wan interface so it uses Nordvpn and replace in the tutorial all Nordvpn interface with my wan interface?
Also i dont quite understand unbound dns. I have checked the documentation here https://docs.opnsense.org/manual/unbound.html but the definition is blurry...what does it mean?

Hi,
I have a simple setup:
(10.0.0.1)Internet box -- (10.0.02) firewall_WAN -- firewall_LAN (192.168.1.1) -- my pc (192.168.1.2)
I would like to set a firewall rule authorizing all packets out and blocking all packets in except for related/established packets (stateful rule).
I dont find the rules i need to add to obtain this.

Could you help me with this?

Thank you.