WAN Failover

[Mundan101]

Hello,

I am trying to setup a WAN failover.

I tried to test the connection and unplugged my WAN ethernet cable and it still showed the interface up even after several minutes of it being plugged in.  It also did tried going to shell and ping the WAN IP address and it actually returned back pingable which was strange.  It never switched over to my wan 2 which I had tested earlier via direction connection to pc and it worked.  Any ideas?

Attached are some screen shots.

[Mundan101]

looks like when I renamed the interfaces it didn't save properly in the gateway monitor.

All is good!