Firewall/NAT rules not applying - Error rules.debug

[barryfo]

Hi All,

Fairly new to OPNSense.  Trying to get a test setup under a qemu VM working.  Tried 18.7 and 19.1 both the iso and nano builds.  Each time I am not getting the basic NAT rules being applied and every time I apply configuration I get the errors as per the attached snapshot.

I am able to get traffic forwarded from the LAN to the WAN but the source IP on the WAN NATed.

This basically happens without anything but the default configuration.   Any help would be appreciated!

Barry

[newsense]

Disable/Enable Bogons on the interface, make sure to save the config each time. That should clear any error or file level issue that may be present.

[barryfo]

Thanks for the tip but that didn't address the issue.  Any other ideas?

[barryfo]

It appears to somewhat be related to QEMU support.  I changed to kvm and things worked fine.  I found this post on pfsense forum where others had the same problem. It is very strange.

https://forum.netgate.com/topic/80013/cannot-define-table-bogons/19

[chemlud]

...sometimes there are glitches in the Matrix, you know....